PDA

View Full Version : Internal Engine


  1. 3.4 heads question
  2. Engine Swap has begun
  3. Manifold spacer?
  4. diving into the engine.
  5. i want to build up my 3.4
  6. Seafoam
  7. grand national
  8. thinking about pistons.
  9. 3.8l Torque specs
  10. 3.4l Engine Numbered Breakdown Diagram
  11. My "OFFICIAL" 3.4 Top End Rebuild Thread!!!!!
  12. rebuild motor
  13. So many options to go with...help?
  14. Cam vs Rocker Q?
  15. Intake Maifold?
  16. Possible New Engine For Me
  17. 3.4 build
  18. 3.8 Spun Bearing issues?
  19. My car is DEAD!
  20. Oil level sensor problem
  21. rocker install gone bad?
  22. 3.4 questions
  23. Rockers
  24. 3.8 cam
  25. Are the Older 3.4 (93-95) and Newer 99+ 3.4s blocks the same?
  26. ? with heads
  27. 3.8l bad juju
  28. priming a remand 3.8 ???
  29. Wrist pins...
  30. Piston tops
  31. vs cam or gt2 cam
  32. abbott racing cam
  33. Ticking sound again
  34. Top end rebuild
  35. Torq specs
  36. Questions on a swap
  37. Aftermarket area for rods, pistons, and cranks
  38. New problem going on long enough. Any suggestions?
  39. Lifters
  40. need help
  41. Cold Start Question
  42. Ticking in 'Drive'
  43. cam install
  44. Rear cover
  45. Torque to yield bolts
  46. 3100 Swap.
  47. ticking below 3000, and only when hot??
  48. The low oil pressure thing happened again, this time no pressure at all
  49. 3.4 Rear Engine/Camshaft Cover Gasket
  50. P0302 - Cylinder 2 Misfire
  51. question
  52. Nas Escobar's engine swap
  53. Ticking from Driver Side Valve Cover