- 3.4 heads question
- Engine Swap has begun
- Manifold spacer?
- diving into the engine.
- i want to build up my 3.4
- Seafoam
- grand national
- thinking about pistons.
- 3.8l Torque specs
- 3.4l Engine Numbered Breakdown Diagram
- My "OFFICIAL" 3.4 Top End Rebuild Thread!!!!!
- rebuild motor
- So many options to go with...help?
- Cam vs Rocker Q?
- Intake Maifold?
- Possible New Engine For Me
- 3.4 build
- 3.8 Spun Bearing issues?
- My car is DEAD!
- Oil level sensor problem
- rocker install gone bad?
- 3.4 questions
- Rockers
- 3.8 cam
- Are the Older 3.4 (93-95) and Newer 99+ 3.4s blocks the same?
- ? with heads
- 3.8l bad juju
- priming a remand 3.8 ???
- Wrist pins...
- Piston tops
- vs cam or gt2 cam
- abbott racing cam
- Ticking sound again
- Top end rebuild
- Torq specs
- Questions on a swap
- Aftermarket area for rods, pistons, and cranks
- New problem going on long enough. Any suggestions?
- Lifters
- need help
- Cold Start Question
- Ticking in 'Drive'
- cam install
- Rear cover
- Torque to yield bolts
- 3100 Swap.
- ticking below 3000, and only when hot??
- The low oil pressure thing happened again, this time no pressure at all
- 3.4 Rear Engine/Camshaft Cover Gasket
- P0302 - Cylinder 2 Misfire
- question
- Nas Escobar's engine swap
- Ticking from Driver Side Valve Cover