View Full Version : ~?Amp Setup Suggestions?~

09-12-2009, 08:37 PM
Here's what im working with, and i'd like to amp all the channels:

Headunit: Sony CDX-GT930UI
Front L&R S: ALPINE SPR-17S (110RMS / 330P)
Sail Panels: CDT Audio M6 -/+ MBD's (120RMS/250P)
Rear L&R S: ((Stock))...soon switching to Alpine SPR-13S's...a beefier 5.25" speaker from the stock 4" (100 RMS/300P)
Addon Sub: MTX RT4500 SUB/MTX 4301 AMP.
**INSTL Kits Are Streetwires Products**
I also have a yellow top battery recently put in for the added demand, alternator is still stock 105amp, but ill be switching that to a 150 powermaster soon, unless there is a higer amperage model outthere with an OEM fit. Also planning on upgrading the wiring to 4ga..
Any suggestions from you guys on the best method for amping them, or any tips would be much appreciated...im pretty good with it but always looking for input!! :wavey:

09-12-2009, 08:53 PM

That is all.

Or perhaps a 6 channel amp for the highs and a mono sub block?



09-12-2009, 09:43 PM
Jim is correct... I love my Memphis Belle so much that it sits in the house while I use Powerbass in the car!!! Gotta love it whe all that chrome sits in the closet!

09-14-2009, 07:50 PM
hmm...i hadnt heard much about the memphis product... i had been looking at the MTX TE1004 to run the front and rear and another MTX to run the sail panels...A three amp core for best power match... But im sure the ease of working with a single unit is appealing, and why not. My only concerns are power matchups....i see the belle runs 75 rms x 6 @ 4 ohms... a good idea on (110-120) nominal rated RMS speakers??

09-14-2009, 07:59 PM
i see the belle runs 75 rms x 6 @ 4 ohms... a good idea on (110-120) nominal rated RMS speakers??


09-14-2009, 08:02 PM
The Belle actually splits the two sides nicely... power side hits like hell with the right subs..and the 4 channel handles the mids and highs great!

09-14-2009, 08:16 PM
Nice.... Mtx gets alot of prestige...but if it bangs for that buck then ill chirp third for that!