Results 1 to 5 of 5

Thread: HOW TO: Remove and Install Steering Wheel and Air Bag!

  1. #1
    Join Date
    Aug 2008
    Location
    Shrewsbury, York County, PA
    Posts
    456
    Rep Power
    12

    Default HOW TO: Remove and Install Steering Wheel and Air Bag!

    1. Disconnect Battery

    2. On the Back of the wheel, There are two open holes. Inside each of these holes are a Torx Bolt. Remove each and the airbag will pull away from the steering wheel.

    3. Unplug the Airbag wiring harness

    4. MAKE SURE YOU WHEELS ARE STRAIGHT. To Pull the wheel you will need a steering wheel puller. You can get these at any auto parts store. There is one bolt in the middle of the Wheel. Using a 1/2" drive ratchet or breaker bar, remove the bolt.

    5. Attach the pulle to the wheel using the two supplied bolts. MAKE SURE YOU USE THE CORRECT THREAD PITCH AND BOLT SIZE.

    6. Tighten the puller Until the wheel Pops off. You will have to unplug the radio control harness and pull the horn wire, which has a spring on the end.

    Installation is the reverse of removal, Just make sure you line the wheel up straight.

    I WILL HAVE IMAGES LATER.
    Y87 Package
    MANUAL CONVERTED, Pro 5.0 Shifter
    Pacesetters, Magnaflow Cat, Cutout, Flowmaster

  2. #2
    Join Date
    Aug 2008
    Location
    Buffalo, N.Y.
    Posts
    2,408
    Rep Power
    14

    Default

    interesting choice of HOW TO, but helpful nonetheless!

    93 3.4 Firebird
    Pacesetter Headers, Flowmaster 80, Comp 1.6 RR, Custom Cam, Cloyes 2x Set, P&P Heads & Intakes, Ram Air Intake, Posi Rear w/3.42's and Disk Brakes, OBD-1 Swap.
    Cam and Heads by 60Inclusive.com Tune By Wot-Tech.com

  3. #3
    Join Date
    Aug 2008
    Location
    douglasville, GA
    Posts
    738
    Rep Power
    12

    Default

    why did you have to remove your steering wheel?

    1996 Camaro 3.8L - SOLD
    2002 Lexus IS300

  4. #4
    Join Date
    Aug 2008
    Location
    Shrewsbury, York County, PA
    Posts
    456
    Rep Power
    12

    Default

    Someone on LS1Tech needed to know how.

    And me? Long story. You can find the thread over on CV6...
    Y87 Package
    MANUAL CONVERTED, Pro 5.0 Shifter
    Pacesetters, Magnaflow Cat, Cutout, Flowmaster

  5. #5
    Join Date
    May 2009
    Posts
    82
    Rep Power
    11

    Default

    i need to do this the guy i bought my car off did not keep the wheel striaght so i only see my tach from like 4.5 up and it sucks

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •